These twelve questions come up on almost every Buying Guides inquiry. The answers are written to be used directly in a listing, a support reply or a supplier brief.

Questions about material and wear

What is it made of, will it tarnish, can it be repaired, and how long will it last. On Buying Guides, the honest answer names the base metal, the plating microns and the replating path.

A vague answer to a material question is the start of a return.

Sample by size run, not from one mixed tray. Defects cluster by size and by design, and a mixed sample hides both.

Questions about size and fit

What size should I order, does a wide band fit differently, can it be resized, and what is the chain length. Publish a chart, a tolerance and a resize limit.

On Buying Guides, those three published lines remove most size tickets.

QuestionShort answerWhere to publish
What is it made ofBase metal, purity, micronsSpec sheet
Will it tarnishPlate thickness, careCare card
Which sizeChart plus toleranceSize guide
Is it a diamondType, lab, numberListing
MOQ and lead timeTier and scheduleWholesale page

Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.

Keep the CAD file and the mould receipt. Ownership is a document, not an understanding.

Questions about stones and claims

Is it a diamond, is it lab grown, does it come with a certificate, and what grade is it. Answer with the type, the lab and the number where one exists.

Never answer a stone question with a comparison. Answer with the specification.

Questions about orders and terms

What is the MOQ, what is the lead time, what are the payment terms, and what happens if a piece is defective. Four commercial answers that belong on the page, not in a reply.

On Buying Guides, publishing those four reduces the inquiry volume and improves the quality of the inquiries that remain.

A repeat order is a test of the factory, not of the design. If the second lot drifts, the process was never controlled, only the sample.

What to check before the order

Run the five checks below in order. The first two protect the money, the last three protect the launch date.

  • Answer material questions with numbers.
  • Publish the size chart and the tolerance.
  • Answer stone questions with the type and lab.
  • Put MOQ and lead time on the page.
  • Publish the defect remedy path.

If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.

Frequently Asked Questions

What do buyers ask most about Buying Guides?

Material, size and stone claims. Those three account for most inquiries and most returns.

How should I answer a stone question?

With the type, the size, the grade and the lab number if one exists. A comparison is not an answer.

Should MOQ be public?

Yes, at tier level. It filters the inquiries and saves both sides time.

What is the best size answer?

A chart with diameter in millimetres, a tolerance and a note on wide bands.

How do I reduce inquiry volume?

Publish the twelve answers. Most inquiries exist because the page did not answer them.

How do I know a supplier is reliable?

Two clean repeat lots and two on-time shipments. Before that it is a sample, not a supplier.

Send the Buying Guides product page. We return the twelve answers written for your spec and your channel. See the full range at Buying Guides and HOLYCOME.

The short version: specify the number, seal the sample, inspect against both. Everything else is negotiation.