Most wedding rings disputes are not about workmanship. They are about a standard that was never written down. An AQL sheet turns 'it looks off' into a measured accept or reject decision both sides can live with.

What AQL actually means on jewelry

AQL is the acceptable quality limit: the percentage of defects a lot may carry and still pass. On wedding rings, AQL 2.5 for major defects and AQL 4.0 for minor is the common commercial setting.

The number matters less than the definition. A loose stone is a major defect. A 0.2 mm polish mark on the gallery is minor. Write both into the sheet.

Write the remedy matrix before the first defect: remake, credit, allowance or rework, each tied to a defect class.

The four defect classes

Critical: sharp edge, wrong alloy, missing stone, nickel release above limit. Major: loose stone, wrong size, plating skip visible at arm's length. Minor: light polish mark, small bubble in the plate. Cosmetic: a mark only visible under a loupe.

Each class needs its own limit and its own remedy. A wedding rings lot that fails critical fails entirely, whatever the AQL number says.

Defect classExampleLimitRemedy
CriticalWrong alloy, missing stone0Reject lot
MajorLoose stone, wrong sizeAQL 2.5Remake or credit
MinorPlating skip, light markAQL 4.0Price allowance
CosmeticLoupe-only polish markNot countedNote only

Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.

Put the forecast window in writing. Capacity priority follows predictability, not friendship.

Sampling that matches the lot size

For 50 pieces, inspect all. For 500, sample 50 by ISO 2859 general level II. For 5,000, sample 80. Inspect by size run and by design, not from one mixed tray.

Photograph the defects you find, with the PO number in frame. A claim without a photo pack is a conversation, not a claim.

Making the standard stick

Put the AQL sheet in the PO as an annex. Require the factory's own inspection record with the carton. Hold the last 10 percent payment against the inspection result.

That structure is what turns a wedding rings QC clause from a sentence into a lever.

In practice, the first lot answers more than the quote does. Weigh ten pieces, measure five stones and rub three contact points, and the specification stops being a claim.

What to check before the order

Run the five checks below in order. The first two protect the money, the last three protect the launch date.

  • Write the defect definitions into the PO annex.
  • Sample by size run, not from one tray.
  • Photograph every defect with the PO number.
  • Hold final payment against inspection.
  • Keep the factory's own QC record with the carton.

If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.

Frequently Asked Questions

What AQL should I use for wedding rings?

AQL 2.5 major and 4.0 minor is the common commercial setting. Critical defects are zero regardless of the AQL.

Do I need a third-party inspection?

For the first two lots, yes. After that, your own incoming check plus the factory record is usually enough.

What counts as a loose stone?

Any stone that moves under light finger pressure, or shows a gap at the prong seat. Test every stone in the sample, not one per tray.

How do I handle a failed lot?

Reject, document, and agree remedy in writing: remake, credit or rework at the factory's cost. Do not accept a discount on a critical defect.

Can QC be done at the factory?

Yes, and it should be, but your inspection is the one that releases payment. Two checks catch more than one.

What belongs in the first email to a new supplier?

Spec, quantity, target price, delivery date and the QC standard. Five lines get a useful reply.

Send the wedding rings spec. We return the AQL annex with defect photos, sampling plan and the remedy matrix you can attach to the PO. See the full range at Wedding Rings and HOLYCOME.

Buyers who get consistent lots are not luckier. They wrote the spec down and checked the first carton against it.