These twelve questions come up on almost every Diamonds & 4Cs inquiry. The answers are written to be used directly in a listing, a support reply or a supplier brief.

Questions about material and wear

What is it made of, will it tarnish, can it be repaired, and how long will it last. On Diamonds & 4Cs, the honest answer names the base metal, the plating microns and the replating path.

A vague answer to a material question is the start of a return.

Seal the approved sample in a bag with the PO number. It is the only physical record that settles a claim without an argument.

Questions about size and fit

What size should I order, does a wide band fit differently, can it be resized, and what is the chain length. Publish a chart, a tolerance and a resize limit.

On Diamonds & 4Cs, those three published lines remove most size tickets.

QuestionShort answerWhere to publish
What is it made ofBase metal, purity, micronsSpec sheet
Will it tarnishPlate thickness, careCare card
Which sizeChart plus toleranceSize guide
Is it a diamondType, lab, numberListing
MOQ and lead timeTier and scheduleWholesale page

Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.

Ask for the plating thickness in microns, then test the contact points on the first lot. A thirty-second cloth rub shows colour transfer before a customer does.

Questions about stones and claims

Is it a diamond, is it lab grown, does it come with a certificate, and what grade is it. Answer with the type, the lab and the number where one exists.

Never answer a stone question with a comparison. Answer with the specification.

Questions about orders and terms

What is the MOQ, what is the lead time, what are the payment terms, and what happens if a piece is defective. Four commercial answers that belong on the page, not in a reply.

On Diamonds & 4Cs, publishing those four reduces the inquiry volume and improves the quality of the inquiries that remain.

Keep the approved sample and the CAD together. One proves what was agreed, the other proves what was made.

What to check before the order

Run the five checks below in order. The first two protect the money, the last three protect the launch date.

  • Answer material questions with numbers.
  • Publish the size chart and the tolerance.
  • Answer stone questions with the type and lab.
  • Put MOQ and lead time on the page.
  • Publish the defect remedy path.

If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.

Frequently Asked Questions

What do buyers ask most about Diamonds & 4Cs?

Material, size and stone claims. Those three account for most inquiries and most returns.

How should I answer a stone question?

With the type, the size, the grade and the lab number if one exists. A comparison is not an answer.

Should MOQ be public?

Yes, at tier level. It filters the inquiries and saves both sides time.

What is the best size answer?

A chart with diameter in millimetres, a tolerance and a note on wide bands.

How do I reduce inquiry volume?

Publish the twelve answers. Most inquiries exist because the page did not answer them.

What is the fastest way to lose money on a first order?

Skip the trial lot and accept an average gram weight. Both hide the problem until rework is at lot scale.

Send the Diamonds & 4Cs product page. We return the twelve answers written for your spec and your channel. See the full range at Diamonds & 4Cs and HOLYCOME.

Buyers who get consistent lots are not luckier. They wrote the spec down and checked the first carton against it.