Vermeil and Gold Plating Specs for care and Maintenance

Vermeil means a gold layer of at least 2.5 microns over sterling silver, and the US market reads that number as a material claim rather than a finish note. Below 2.5 microns the piece is gold-plated, not vermeil, and the word cannot be used, with GRA report and retail box with care card stated on the same sheet.

We run 3 microns on care and Maintenance for accounts that publish the claim, with a palladium strike layer so wear-through reads white and not yellow. Thickness is logged per lot and appears on the GRA report batch sheet, quoted at USD 12-67 per piece in retail box with care card.

Care & Maintenance wholesale piece from the HOLYCOME line in Wuzhou

The cost difference is real: the USD 12-67 band moves up roughly sixty percent against rhodium-finished silver, and the retail price has to carry that or the margin disappears in the second season when the plating shows wear.

MOQ, Mixed Designs and the Real First Order

Last May, a US buyer of care and Maintenance placed 100 care and Maintenance against a sample signed in September. The first container landed with 9 pieces that failed on tarnish in transit alone, and USD 10-30 landed on the buyer's P&L before a single unit sold, on a 100-piece Vermeil Upgrade order at USD 12-67.

On a 100-piece order at USD 12-67, a tarnish in transit rate above two percent is not a quality surprise. It is a costing error that shows up as a credit note three weeks later.

Nothing in the rebuild was expensive. A gauge, a written limit and a retained tray did the work that a discount would only have delayed, and 100 pieces leaves Wuzhou in retail box with care card at USD 12-67.

Care & Maintenance setting and finish detail on a HOLYCOME factory sample

The Three Failures We See Most in Incoming Samples

tarnish in transit

Silver that ships without an anti-tarnish strip browns in a humid container. The strip costs 3 cents and removes the most common arrival complaint, with GRA report and retail box with care card stated on the same sheet.

Our countermeasure is a gauge and a written limit. It adds about 11 seconds per piece and removes the defect from the run rather than from the carton, with GRA report and retail box with care card stated on the same sheet.

rhodium adhesion

A silver surface plated without a palladium strike layer blisters in wear. The strike layer is invisible and essential, quoted at USD 12-67 per piece in retail box with care card.

In a 100-piece run this typically shows on 17 of pieces. Catching it means measuring silver assay at 92.5% minimum at the tray level, not inspecting the finished carton, and at USD 12-67 for 100 pieces that is the number the buyer signs.

weight shortfall

A 2.1 g ring shipped at 1.85 g passes a casual check and fails a scale. Publish the weighed average per SKU, and the Vermeil Upgrade quote for it sits at USD 12-67.

The commercial effect is tarnish claims and replacements, typically USD 4-7 per piece. Buyers who have seen it once put it in the purchase order; buyers who have not usually discover it on the first return, quoted at USD 12-67 per piece in retail box with care card.

Where USD 12-67 Per Piece Actually Goes

Cost at USD 12-67 leaves no room for assumption. The table shows which line compresses and which line only moves quality down.

Cost lineShareWhat moves it
Base metal or alloy for care and Maintenance30%Alloy choice and casting yield
Stone or melee for care and Maintenance20%Sieve range and lot batching
Setting and finishing labor for care and Maintenance19%Jig design and bench minutes
Plating, polish and QC for care and Maintenance12%Per-tray versus per-piece checks
Packaging for care and Maintenance19%retail box with care card

A factory that cannot state its bench minutes per piece has never costed its own line. Ask for minutes and for the reject rule, not for a discount, certified GRA report and packed retail box with care card at 100 pieces, which the Vermeil Upgrade file records at USD 12-67 in retail box with care card.

What US buyers Check Before They Sign

At USD 12-67 per piece the four measurements below are worth more than the discount being negotiated. One of them costs nothing to write down.

Spec pointCommon trade outputHOLYCOME standardCost if missed
Plating thicknessNominal only0.20 micron rhodium logged per lot, 3 microns on vermeilWear-through inside one season
Surface porosity after polishSeen after platingCast porosity checked before plating, rejects pulled at that stagePlating blister six weeks later
Stone colour consistencyGraded by eye under D65Colour matched to a retained master stone, per trayRepeat colour complaint in the same SKU
Sizing drift across the runNot measuredGo/no-go gauge on every size, drift held under 0.15 mmResize queue and reship cost

Write these into the Vermeil Upgrade purchase order and the arrival check becomes arithmetic instead of recollection, the figure being USD 12-67 for a 100-piece run.

Order Terms, Sample Timing and Packing

The commercial frame is short enough to state in full. Minimum order is 50 pieces per design, and mixed designs travel in one shipment, so a 100-piece Vermeil Upgrade order can carry three or four models without a separate setup charge. Sample pieces leave in 3-5 days when the components are in stock, and a new model adds about twenty days before the first article exists, shipped as retail box with care card and certified GRA report.

Payment is 30 percent with the order and 70 percent against the bill of lading, with the balance window stated on the invoice rather than agreed by message. Prices quoted at USD 12-67 are FOB Guangzhou or Shenzhen; DDP is quoted separately because the duty line moves with the tariff schedule and not with our cost.

Packing follows the retail box with care card format at 100 pieces to the carton, and the packing list carries SKU, size and stone size so receiving can count without opening every box. Private-label cartons add three days for the print run and must be approved before the first bulk order, not after it, shipped as retail box with care card and certified GRA report.

Certification is GRA report for the lots that carry it, with a batch report and per-piece measurement of silver assay at 92.5% minimum for the lots below the threshold. The document set travels with the shipping papers, which is what a customs broker asks for at the port rather than after clearance, and the Vermeil Upgrade quote for it sits at USD 12-67.

A rejected tray is settled inside the same order cycle against the retained reference piece. If the difference sits on our retained sample we replace or credit; if it appeared in transit we split the assay cost and file with the carrier, and that rule is written on the order before the deposit clears, with GRA report and retail box with care card stated on the same sheet.

AQL, Tray Checks and What a QC Report Should Say

The answer for care and Maintenance depends on four variables, and three of them are under the buyer's control, with GRA report and retail box with care card stated on the same sheet.

We run this check per tray rather than per carton because the defect that matters on care and Maintenance is the one that repeats. A single odd piece is noise; a pattern across one tray is a process problem and it will be in every tray made after it, the figure being USD 12-67 for a 100-piece run.

The report the buyer receives states the count per tray, the measured average and the outlier count for care and Maintenance. It is deliberately unglamorous, and it is the document that settles most disputes before they start, on a 100-piece Vermeil Upgrade order at USD 12-67.

Carton Cube, Duty and the Freight Line That Surprises Buyers

In the American bridal market, this is the single most negotiated line on care and Maintenance and the least documented one, which the Vermeil Upgrade file records at USD 12-67 in retail box with care card.

The buyers who get the most out of care and Maintenance treat the first order as a measurement, not as a purchase. They buy a small run, measure the four numbers that matter, and then commit, certified GRA report and packed retail box with care card at 100 pieces.

We support it directly on care and Maintenance: a 50-piece test run per design, the same gauge standard as a bulk order, and the same retained tray. Small does not have to mean loose, shipped as retail box with care card and certified GRA report.

Freight, Duty and the Arrival Check

Export runs through Guangzhou or Shenzhen. Air lands in 5-8 days on the US west coast, 7-10 on the east, and sea takes roughly three times the transit, and at USD 12-67 for 100 pieces that is the number the buyer signs.

FOB is the default on care and Maintenance and DDP is the option. Buyers new to the American bridal market usually take DDP once, then switch after they see the breakdown, which is USD 12-67 on the Vermeil Upgrade schedule.

If tarnish in transit appears in the arrival check, the retained tray decides who owns it. Keep the GRA report batch sheet in the same folder as the packing list, priced at USD 12-67 for the 100-piece Vermeil Upgrade run.

How a Repeat Order Gets Built

Nothing in this sequence is unusual, and that is the point. Each step exists because skipping it produced a specific failure on a previous order, the figure being USD 12-67 for a 100-piece run.

  1. Sign the drawing at 1:1 scale with a millimetre grid, not a phone render.
  2. Cut the model in wax or resin and photograph it on the gauge before metal is committed.
  3. Cast the first article, set the stones and finish it exactly as bulk will be finished.
  4. Send the first article for approval with the weight and the stone measurements stated.
  5. Run the balance of the order in 25-30 days, holding the approved article as the reference.
  6. Ship with the approved article photographed beside a production piece from the same tray.

Reorders inside this sequence run 12-15 days because the model, the gauge set and the signed spec stay in our system, shipped as retail box with care card and certified GRA report, which is USD 12-67 on the Vermeil Upgrade schedule.

What This Means for a First Order

A first Vermeil Upgrade order of 50 pieces per design at USD 12-67 tests the line rather than the range. Three designs covers the shelf.

Ask for the retained tray and the GRA report batch sheet with the first shipment. Both are free and both decide the reorder, priced at USD 12-67 for the 100-piece Vermeil Upgrade run.

Frequently Asked Questions

How long does a reorder of the same care and Maintenance take?

With the model, the gauge set and the signed spec already in our system, a repeat is 12-15 days; a first run is 3-5 days for a stock-component sample and about 20 days when a new model is needed, on a 100-piece Vermeil Upgrade order at USD 12-67.

What finish do you use, and how thick is it?

Rhodium at 0.20 micron minimum on white care and Maintenance, with a palladium strike layer so wear-through reads white rather than yellow. Vermeil runs at 3 microns over sterling and is logged per lot, with GRA report and retail box with care card stated on the same sheet.

How is care and Maintenance packed for retail box with care card?

Every unit goes into a foam-backed pouch, then the retail box with care card, then the outer carton at 100 pieces. The packing list carries the SKU, the size and the stone size so receiving can check without opening every box, which is USD 12-67 on the Vermeil Upgrade schedule.

Can you ship DDP?

DDP is available for US accounts and removes the duty invoice that arrives after the carton clears. FOB Guangzhou or Shenzhen is the default, and most buyers take DDP once and then switch after they see the breakdown, and 100 pieces leaves Wuzhou in retail box with care card at USD 12-67.

How long does a reorder of the same care and Maintenance take?

With the model, the gauge set and the signed spec already in our system, a repeat is 12-15 days; a first run is 3-5 days for a stock-component sample and about 20 days when a new model is needed, on a 100-piece Vermeil Upgrade order at USD 12-67.

Next Step

The next step is a sample in 3-5 days, not a container. Write to service@holycome.com or WhatsApp +86 18078079070, subject Vermeil Upgrade, quoted at USD 12-67 per piece in retail box with care card.

HOLYCOME is operated by Wuzhou HengliLai Jewelry Co., Ltd., a factory in Wuzhou, Guangxi, producing since 2009 at roughly 60,000 pieces a month. Contact service@holycome.com or WhatsApp +86 18078079070, which is how the Vermeil Upgrade account reads it at USD 12-67.

Related reading: Care & Maintenance Amazon FBA Ready: Sample to Container: The Real Calendar - HOLYCOME Wedding Rings Made to Order: The Reject Tray Policy That Decides a Partnership - HOLYCOME