Two Care & Maintenance pieces at very different prices are usually separated by six variables, not by brand. Knowing their weight lets you move a price point without breaking the product.

Variables one and two: metal weight and purity

Metal is the largest line on most Care & Maintenance quotes. A 1.6 mm band and a 2.2 mm band differ in weight by around 40 percent, and purity multiplies that again.

If a price has to come down, weight is the honest lever; a lighter band can be a legitimate tier. Reducing plating is not.

Photograph the first article before the batch runs. A shifted seat or a short prong is cheapest to fix at one piece.

Variables three and four: stone and setting

Stone grade and setting labour move together. A certified stone adds a report cost; a bezel setting adds bench time but removes prong maintenance.

On Care & Maintenance, the stone is usually the second-largest line and the easiest to over-specify.

VariableShare of costLeverRisk
Metal weight30-45%Band thicknessPerceived quality
PurityMultiplierKaratPrice band
Stone15-35%Grade, sizeLook
Setting10-20%StyleMaintenance
Plating5-10%MicronsReturns
Volume6-16%TierCommitment

Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.

Keep the CAD file and the mould receipt. Ownership is a document, not an understanding.

Variables five and six: finishing and volume

Plating thickness and the volume tier decide the last 15 to 25 percent. A thicker plate costs more per piece and less per claim.

Volume discounts are real only when they map to a cost driver: alloy purchase, plating batch, bench learning, freight consolidation.

Moving a price point without breaking it

Change one variable at a time and re-check the spec. A price cut that changes two variables at once produces a product nobody can describe.

On Care & Maintenance, the cleanest lever is weight, then stone size, then plating, in that order.

Capacity is the constraint that price cannot solve. In peak season a cheaper factory with no slot is more expensive than a dearer one with a date.

What to check before the order

Run the five checks below in order. The first two protect the money, the last three protect the launch date.

  • Know the share of each variable.
  • Change one variable at a time.
  • Use weight first when cutting price.
  • Never cut plating to hit a price.
  • Tie volume discounts to cost drivers.

If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.

Frequently Asked Questions

Why is one Care & Maintenance twice the price of another?

Usually metal weight, purity and stone grade. Those three account for most of the gap.

How can I lower a price point honestly?

Reduce weight or stone size as a stated tier. Do not reduce plating or stone grade silently.

Does a thicker plate raise the price much?

A few percent per piece, and it usually lowers the claim rate. The net effect is often neutral.

Are volume discounts always real?

Only when they map to a cost driver. Otherwise they are a temporary margin transfer.

What is the safest variable to change?

Band thickness, because it is visible and easy to describe in a tier.

What is the fastest way to lose money on a first order?

Skip the trial lot and accept an average gram weight. Both hide the problem until rework is at lot scale.

Send the Care & Maintenance current price and target. We return the six-variable model with the lever that moves the price without breaking the spec. See the full range at Care & Maintenance and HOLYCOME.

None of this is exotic. It is a document, a measurement and a date, repeated until it becomes a process.